Difficulty
Easy
Steps
9
Time Required
6 minutes
Sections
2
- Front Cover
- 5 steps
- Back Cover
- 4 steps
Flags
0
BackCanon PowerShot A2300
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Cover
- Open the A/V Out Digital port cover on the function button side to reveal a screw.
Open the A/V Out Digital port cover on the function button side to reveal a screw.
1024
Step 2
- Remove all 6 screws(2.70 mm), 2 on each side and 2 on the bottom.
- Screws are small and very easily lost.
Remove all 6 screws(2.70 mm), 2 on each side and 2 on the bottom.
Screws are small and very easily lost.
Step 3
- Open the card/battery latch by sliding the cover away from the camera in the direction indicated by the arrow.
- Doing this gives a spot to grip on the bottom of the front cover. This will make it easier to handle when removing.
Open the card/battery latch by sliding the cover away from the camera in the direction indicated by the arrow.
Doing this gives a spot to grip on the bottom of the front cover. This will make it easier to handle when removing.
Step 4
- Gently lift the bottom of the front cover to roughly a 30 degree angle.
Gently lift the bottom of the front cover to roughly a 30 degree angle.
Step 5
- Pull the top of the front cover away from the camera by gripping the top of the front cover by the corners where the cover is still attached to the body.
Pull the top of the front cover away from the camera by gripping the top of the front cover by the corners where the cover is still attached to the body.
Step 6
Back Cover
- Hold the camera in your hands with both thumbs on the screen with the screen faced up.
- Keep close to the table top in case the camera falls out of your hands.
Hold the camera in your hands with both thumbs on the screen with the screen faced up.
Keep close to the table top in case the camera falls out of your hands.
Step 7
- Pull the the bottom left corner of the cover up about an inch to the point shown in the picture.
- Do not completely remove the back cover by pulling on the side as shown. The cover is still attached on the top of the camera.
Pull the the bottom left corner of the cover up about an inch to the point shown in the picture.
Do not completely remove the back cover by pulling on the side as shown. The cover is still attached on the top of the camera.
Step 8
- Pry the top off by sliding the spudger under the On/Off button.
Pry the top off by sliding the spudger under the On/Off button.
Step 9
- Slide the cover to the right and off the camera.
- Gently pry using the spudger on the right side if necessary.
- The A/V OUT DIGITAL cover will sometimes become loose and disconnect from the cover
Slide the cover to the right and off the camera.
Gently pry using the spudger on the right side if necessary.
The A/V OUT DIGITAL cover will sometimes become loose and disconnect from the cover
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Nathan McMillan
Member since: 03/23/2015
357 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
Baylor, Team 7-14, Williams Spring 2015
Member of Baylor, Team 7-14, Williams Spring 2015
BU-WILLIAMS-S15S7G14
4 Members
10 Guides authored
s0o149563 - Jun 24, 2020
Reply
How to share in photo camera to mobile
How to share photos camera to mobile
