Difficulty

Difficult

Steps

7

Time Required

                          10 - 15 minutes

Sections

3

  • Back Cover
  • 2 steps
  • Front Cover
  • 1 step
  • LCD Display
  • 4 steps

Flags

1

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

  • BackCanon Powershot A3300 IS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove four 2.7 mm screws, two on each side, from the camera with a JIS 000 screwdriver.
  • Remove one 3.5 mm screw on the bottom of the camera with a JIS 000 screwdriver.
  • When removing the front and back housings, be careful to not break the tabs that hook into the top section of the chassis.

Remove four 2.7 mm screws, two on each side, from the camera with a JIS 000 screwdriver.

Remove one 3.5 mm screw on the bottom of the camera with a JIS 000 screwdriver.

When removing the front and back housings, be careful to not break the tabs that hook into the top section of the chassis.

1024

Step 2

  • Pull off the back cover.

Pull off the back cover.

Step 3

              Front Cover
  • Pull the front cover off.

Pull the front cover off.

Step 4

              LCD Display
  • Use a JIS 000 screwdriver and remove the 3.0mm screw from the bottom housing.

Use a JIS 000 screwdriver and remove the 3.0mm screw from the bottom housing.

Step 5

  • Gently lift the LCD screen off the back of the camera.

Gently lift the LCD screen off the back of the camera.

Step 6

  • Use tweezers to pull out the circled brown flat flexible wire from its connection.

Use tweezers to pull out the circled brown flat flexible wire from its connection.

Step 7

  • Use a spudger to reach under the connecting wire.
  • Gently slide the spudger under the wire and lift the wire off the connection.

Use a spudger to reach under the connecting wire.

Gently slide the spudger under the wire and lift the wire off the connection.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Kenny Chui

Member since: 10/17/2017

107 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       UC Santa Barbara, Team S2-G7, Weedon Fall 2017                        

                                                  Member of UC Santa Barbara, Team S2-G7, Weedon Fall 2017 



                    UCSB-WEEDON-F17S2G7                     


                                            4 Members                     


                                            10 Guides authored