Difficulty

Difficult

Steps

10

Time Required

                          10 - 15 minutes

Sections

3

  • Back Cover
  • 2 steps
  • Front Cover
  • 1 step
  • Motherboard
  • 7 steps

Flags

0

  • BackCanon Powershot A3300 IS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove four 2.7 mm screws, two on each side, from the camera with a JIS 000 screwdriver.
  • Remove one 3.5 mm screw on the bottom of the camera with a JIS 000 screwdriver.
  • When removing the front and back housings, be careful to not break the tabs that hook into the top section of the chassis.

Remove four 2.7 mm screws, two on each side, from the camera with a JIS 000 screwdriver.

Remove one 3.5 mm screw on the bottom of the camera with a JIS 000 screwdriver.

When removing the front and back housings, be careful to not break the tabs that hook into the top section of the chassis.

1024

Step 2

  • Pull off the back cover.

Pull off the back cover.

Step 3

              Front Cover
  • Pull the front cover off.

Pull the front cover off.

Step 4

              Motherboard
  • Remove the black cover to expose the motherboard.

Remove the black cover to expose the motherboard.

Step 5

  • Remove the shutter button located at the top left of the camera.
  • This will expose the screws that need to be removed.

Remove the shutter button located at the top left of the camera.

This will expose the screws that need to be removed.

Step 6

  • Using a JIS 000 screwdriver, remove the 1.2mm screw at the top left of the motherboard.

Using a JIS 000 screwdriver, remove the 1.2mm screw at the top left of the motherboard.

Step 7

  • Remove the 1.6mm screw at the top of the camera.

Remove the 1.6mm screw at the top of the camera.

Step 8

  • Use tweezers to pull out brown flat flexible wires from their connection.
  • Remember to gently wiggle the wires from the connection since they are very fragile connectors.

Use tweezers to pull out brown flat flexible wires from their connection.

Remember to gently wiggle the wires from the connection since they are very fragile connectors.

Step 9

  • Remove the last 1.2mm screw to pull out the motherboard.
  • The motherboard should freely separate from the housing.

Remove the last 1.2mm screw to pull out the motherboard.

The motherboard should freely separate from the housing.

Step 10

  • Remove motherboard and replace with a new one.

Remove motherboard and replace with a new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Phillip Chen

Member since: 10/17/2017

434 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UC Santa Barbara, Team S2-G7, Weedon Fall 2017                        

                                                  Member of UC Santa Barbara, Team S2-G7, Weedon Fall 2017 



                    UCSB-WEEDON-F17S2G7                     


                                            4 Members                     


                                            10 Guides authored