Canon Powershot A80 Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          15 - 30 minutes            

Sections

1

• LCD Screen
• 5 steps

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

• BackCanon PowerShot A80

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              LCD Screen               

• Using a Phillips #00 screwdriver, remove the two 2.9 mm screws on the side of the LCD screen.

Using a Phillips #00 screwdriver, remove the two 2.9 mm screws on the side of the LCD screen.

1024

Step 2

• Using a Phillips #00 screwdriver, remove the 2.9 mm screws on the other side of the screen to separate the front and back covers.
• To access the second screw, rotate the screen 90° so that it faces upwards.

Using a Phillips #00 screwdriver, remove the 2.9 mm screws on the other side of the screen to separate the front and back covers.

To access the second screw, rotate the screen 90° so that it faces upwards.

Step 3

• Gently remove the front and back covers from the screen.
• Peel back the plastic circuit cover.

Gently remove the front and back covers from the screen.

Peel back the plastic circuit cover.

Step 4

• Pull the screen away from the base.
• This will take some force, but remember to handle with care.
• If a small metal piece between the screen cover and the screen falls out during repair, replace it with the rounded corners facing away from the screen during reassembly.

Pull the screen away from the base.

This will take some force, but remember to handle with care.

If a small metal piece between the screen cover and the screen falls out during repair, replace it with the rounded corners facing away from the screen during reassembly.

Step 5

• Unplug the ribbon cable connected to the circuit board latch.

Unplug the ribbon cable connected to the circuit board latch.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.                                             

Author

                                      with 12 other contributors 

                    konrad                     

Member since: 01/11/2011

220 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 7-31, Regan Winter 2011                        

                                                  Member of Cal Poly, Team 7-31, Regan Winter 2011 



                    CPSU-REGAN-W11S7G31                     


                                            6 Members                     


                                            12 Guides authored                     

yu123xi - Nov 3, 2016

Reply

MY screen is dark after touched water, do I need to change this screen? Where can I buy this screen? How much?

Thank you for the guidance.

jennifer

yu123xi@yahoo.com