Difficulty

Moderate

Steps

8

Time Required

                          10 - 15 minutes

Sections

1

  • Power/Shutter Button Panel
  • 8 steps

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackCanon PowerShot ELPH330 HS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power/Shutter Button Panel
  • On the top-center of your device, turn off the camera by pressing the power button.
  • Put your finger on the battery door and slide the battery door to the right to open it.
  • Push the release button downward and it will release the battery.

On the top-center of your device, turn off the camera by pressing the power button.

Put your finger on the battery door and slide the battery door to the right to open it.

Push the release button downward and it will release the battery.

1024

Step 2

  • Use the Phillips #00 screwdriver to remove the screws.

Use the Phillips #00 screwdriver to remove the screws.

Step 3

  • Remove the two 4.0mm screws on the bottom of the camera located near the battery door using a Phillips #00 screwdriver.

Remove the two 4.0mm screws on the bottom of the camera located near the battery door using a Phillips #00 screwdriver.

Step 4

  • At the bottom of the camera next to the battery door, remove two more screws using the Phillips #00 screwdriver.

At the bottom of the camera next to the battery door, remove two more screws using the Phillips #00 screwdriver.

Step 5

  • To remove the back portion of the camera case, use your fingers to carefully pry the case apart at the seam.

To remove the back portion of the camera case, use your fingers to carefully pry the case apart at the seam.

Step 6

  • On the motherboard there should be a white port. Using the spudger, disconnect it from the motherboard.

On the motherboard there should be a white port. Using the spudger, disconnect it from the motherboard.

Step 7

  • Follow the green and white wire. There is a gray piece of rubber holding the button into place. Remove it with the spudger.

Follow the green and white wire. There is a gray piece of rubber holding the button into place. Remove it with the spudger.

Step 8

  • Lift the panel off from the top of the camera with your hands.

Lift the panel off from the top of the camera with your hands.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Michelle Ngo

Member since: 07/23/2019

595 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       UW Tacoma, Team S1-G3, Liner Summer 2019                        

                                                  Member of UW Tacoma, Team S1-G3, Liner Summer 2019 



                    UWT-LINER-SU19S1G3                     


                                            4 Members                     


                                            3 Guides authored