Difficulty
Difficult
Steps
6
Time Required
40 - 50 minutes
Sections
1
- The Lens of a Cannon Powershot Pro1
- 6 steps
Flags
0
BackCanon Powershot Pro1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
The Lens of a Cannon Powershot Pro1
- Have the lens of the camera facing upwards.
- Find the red plastic ring.
- Look for two small opening above the red plastic ring.
- Reference to the left of the picture and you will see the orange square.
Have the lens of the camera facing upwards.
Find the red plastic ring.
Look for two small opening above the red plastic ring.
Reference to the left of the picture and you will see the orange square.
1024
Step 2
- Remove the plastic ring that has a red strip.
- Remove the 1.5 mm Phillips #1 screws which lie underneath the ring.
Remove the plastic ring that has a red strip.
Remove the 1.5 mm Phillips #1 screws which lie underneath the ring.
Step 3
- Place the camera on its back with the lens facing upwards as shown in the image
- Remove the additional 1.5 mm Phillip #1 screw from underneath the lens cover
- Remove the screw by turning the Philip driver counterclockwise.
- By removing the screw, you will be able to remove the cover lens.
Place the camera on its back with the lens facing upwards as shown in the image
Remove the additional 1.5 mm Phillip #1 screw from underneath the lens cover
Remove the screw by turning the Philip driver counterclockwise.
By removing the screw, you will be able to remove the cover lens.
Step 4
- Use the nylon spudger to remove the ring holding the lens in place.
- Pull gently until the lens ring snaps off.
Use the nylon spudger to remove the ring holding the lens in place.
Pull gently until the lens ring snaps off.
Step 5
- Refer to the left-hand pictere to see what the len’s ring looks like.
Refer to the left-hand pictere to see what the len’s ring looks like.
Step 6
- Take out the lens once the plastic ring is removed
- Hold the outer layer of the lens to not create smudges on it.
- Replace the lens and follow the instruction in reversed order to reassemble the camera.
Take out the lens once the plastic ring is removed
Hold the outer layer of the lens to not create smudges on it.
Replace the lens and follow the instruction in reversed order to reassemble the camera.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Seana Meegan
Member since: 09/06/2019
639 Reputation
5 Guides authored
Badges:
6
+3 more badges
Team
University of Alabama, Team S1-G1, Bedsole Fall 2019
Member of University of Alabama, Team S1-G1, Bedsole Fall 2019
UA-BEDSOLE-F19S1G1
3 Members
10 Guides authored
