Canon Powershot S100 Outer Case Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Outer Case
3 steps

Flags

BackCanon PowerShot S100
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Outer Case

Remove the 2 screws (3.2mm, Phillips #00) found on the bottom side of the camera.
Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera.
Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera where the terminals are.
Open the flap revealing the cable inputs and remove the final screw (3.8mm, Phillips #00) found inside.

Remove the 2 screws (3.2mm, Phillips #00) found on the bottom side of the camera.

Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera.

Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera where the terminals are.

Open the flap revealing the cable inputs and remove the final screw (3.8mm, Phillips #00) found inside.

1024

Step 2

Turn the camera so that the LCD screen is facing you.
Remove the back panel by pulling it off of the camera.

Turn the camera so that the LCD screen is facing you.

Remove the back panel by pulling it off of the camera.

Step 3

Turn the camera so that the lens is facing you.
Do not pull the front panel off without removing the ribbon cable first.
Slowly lift the front panel from the camera.
The ribbon cable is connecting the front panel to the camera. Using the tweezers, gently pull the ribbon cable out of its socket.
A spudger may also be used to remove the ribbon cable.
Remove the rubber guard that rests on top of the lens.

Turn the camera so that the lens is facing you.

Do not pull the front panel off without removing the ribbon cable first.

Slowly lift the front panel from the camera.

The ribbon cable is connecting the front panel to the camera. Using the tweezers, gently pull the ribbon cable out of its socket.

A spudger may also be used to remove the ribbon cable.

Remove the rubber guard that rests on top of the lens.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Ricky

Member since: 02/23/2015

937 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team 1-4, Leahy Winter 2015                        

                                                  Member of USF Tampa, Team 1-4, Leahy Winter 2015 



                    USFT-LEAHY-W15S1G4                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team