Canon Powershot S110 Option Dial Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Option Dial
7 steps

Flags

BackCanon PowerShot S110
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Option Dial

Remove the battery by sliding open the battery cover on the bottom of the camera.
The battery must be removed to avoid shorting out any part of the camera.

Remove the battery by sliding open the battery cover on the bottom of the camera.

The battery must be removed to avoid shorting out any part of the camera.

1024

Step 2

Remove the six screws by using a small Phillips head screwdriver.
Remove the two screws on the side of the camera on either side of the HDMI input panel.
Remove the two screws on the opposite side of the camera.
Remove the two screws on the bottom of the camera located on either side of the tripod mounting hole.

Remove the six screws by using a small Phillips head screwdriver.

Remove the two screws on the side of the camera on either side of the HDMI input panel.

Remove the two screws on the opposite side of the camera.

Remove the two screws on the bottom of the camera located on either side of the tripod mounting hole.

Step 3

Using an opening tool, carefully remove the outermost cover of the camera from its holders around the edges.
Once all of the clips around the plastic cover are released, the cover will lift off.

Using an opening tool, carefully remove the outermost cover of the camera from its holders around the edges.

Once all of the clips around the plastic cover are released, the cover will lift off.

Step 4

Remove the two screws holding the top plastic bracket in place by using a Phillips head screwdriver.
Remove the screw holding down the lens cover.
Remove the screw located near the option dial next to the USB connections.

Remove the two screws holding the top plastic bracket in place by using a Phillips head screwdriver.

Remove the screw holding down the lens cover.

Remove the screw located near the option dial next to the USB connections.

Step 5

Carefully lift the top panel of the camera by using a prying tool.

Carefully lift the top panel of the camera by using a prying tool.

Step 6

Remove the screw at the center of the option dial by using a Phillips head screwdriver.

Remove the screw at the center of the option dial by using a Phillips head screwdriver.

Step 7

Remove the underlying component that was attached to the now-removed screw by using a prying tool.
Remove the dial on the opposite side of the part using a prying tool.

Remove the underlying component that was attached to the now-removed screw by using a prying tool.

Remove the dial on the opposite side of the part using a prying tool.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 6 other contributors

                    akac92

Member since: 07/14/2015

298 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UW Tacoma, Team 1-2, Liner SU 2015                        

                                                  Member of UW Tacoma, Team 1-2, Liner SU 2015 



                    UWT-LINER-SU15S1G2                     


                                            4 Members                     


                                            3 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team