Difficulty
Very easy
Steps
3
Time Required
2 minutes
Sections
1
- Front and Rear Covers
- 3 steps
Flags
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
BackCanon PowerShot SD1200 IS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front and Rear Covers
- Remove the battery.
Remove the battery.
1024
Step 2
- Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)
- Remove the two screws from the bottom of the camera. (4mm Phillips 00)
- Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)
Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)
Remove the two screws from the bottom of the camera. (4mm Phillips 00)
Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)
Step 3
- Pull off the front cover.
- If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.
- Remove the back cover.
Pull off the front cover.
If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.
Remove the back cover.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Jeff Casper
Member since: 09/15/2016
848 Reputation
7 Guides authored
Badges:
18
+15 more badges
Team
USF Tampa, Team 17-5, Blackwell Fall 2016
Member of USF Tampa, Team 17-5, Blackwell Fall 2016
USFT-BLACKWELL-F16S17G5
3 Members
7 Guides authored
