Difficulty
Moderate
Steps
4
Time Required
4 - 10 minutes
Sections
1
- Screen
- 4 steps
Flags
2
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackCanon PowerShot SD1300 IS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Screen
- Remove the two 2mm J00 screws on the right exterior.
- Remove a single 4 mm J00 on the bottom exterior.
- Remove a single 3mm J00 on the left exterior.
Remove the two 2mm J00 screws on the right exterior.
Remove a single 4 mm J00 on the bottom exterior.
Remove a single 3mm J00 on the left exterior.
1024
Step 2
- Once the front shell of the camera is removed the back shell should slide off just the same.
Once the front shell of the camera is removed the back shell should slide off just the same.
Step 3
- Use one of your plastic opening tools to separate the screen from the main body of your PowerShot.
Use one of your plastic opening tools to separate the screen from the main body of your PowerShot.
Step 4
- Hold screen and remove connecting power cord by pulling cord away from the faulty screen.
Hold screen and remove connecting power cord by pulling cord away from the faulty screen.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Clayton
Member since: 03/20/2017
560 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
Texas Tech, Team S13-G1, Bennett Spring 2017
Member of Texas Tech, Team S13-G1, Bennett Spring 2017
TTU-BENNETT-S17S13G1
5 Members
5 Guides authored
