Difficulty

Moderate

Steps

14

Time Required

                          15 - 30 minutes

Sections

1

  • USB Port
  • 14 steps

Flags

0

  • BackCanon PowerShot SD1400 IS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              USB Port
  • Remove the four 2mm Phillips #00 screws on both sides of the camera.

Remove the four 2mm Phillips #00 screws on both sides of the camera.

1024

Step 2

  • Remove the single 4mm Phillips #00 screw from the bottom.

Remove the single 4mm Phillips #00 screw from the bottom.

Step 3

  • Remove the front face panel off of the camera.

Remove the front face panel off of the camera.

Step 4

  • Remove the rear panel of the camera.
  • The user interface panel, side and bottom panel of the camera may fall down by itself while you are taking the rear panel of the camera.

Remove the rear panel of the camera.

The user interface panel, side and bottom panel of the camera may fall down by itself while you are taking the rear panel of the camera.

Step 5

  • Remove the 3mm Phillips #000 screw from the top of the camera.

Remove the 3mm Phillips #000 screw from the top of the camera.

Step 6

  • Pry the golden ribbon cable from the motherboard with a plastic opening tool.
  • A screw will be visible underneath the golden ribbon after prying it.

Pry the golden ribbon cable from the motherboard with a plastic opening tool.

A screw will be visible underneath the golden ribbon after prying it.

Step 7

  • Remove the 3mm Phillips #000 screw from the motherboard.

Remove the 3mm Phillips #000 screw from the motherboard.

Step 8

  • Use a plastic opening tool to flip up the retaining flap on the ribbon cable ZIF socket.

Use a plastic opening tool to flip up the retaining flap on the ribbon cable ZIF socket.

Step 9

  • Unplug the small chip from the face of the camera using a pair of tweezers.

Unplug the small chip from the face of the camera using a pair of tweezers.

Step 10

  • Remove the 3mm Phillips #000 screw from the rear face of the camera.

Remove the 3mm Phillips #000 screw from the rear face of the camera.

Step 11

  • Remove the top panel from the camera.

Remove the top panel from the camera.

Step 12

  • Pry the golden ribbon cable attached to the USB port using a plastic opening tool.

Pry the golden ribbon cable attached to the USB port using a plastic opening tool.

Step 13

  • Remove the 3mm Phillips #000 screw located at the top right of the USB port.

Remove the 3mm Phillips #000 screw located at the top right of the USB port.

Step 14

  • Remove the USB port.

Remove the USB port.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Faris Rezwan

Member since: 05/21/2018

457 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       IUPUI, Team S1-G2, Harley Spring 2018                        

                                                  Member of IUPUI, Team S1-G2, Harley Spring 2018 



                    IUPUI-HARLEY-S18S1G2                     


                                            7 Members                     


                                            4 Guides authored