Difficulty
Easy
Steps
5
Time Required
10 - 15 minutes
Sections
1
- User Interface Panel
- 5 steps
Flags
0
BackCanon PowerShot SD1400 IS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
User Interface Panel
- Remove the four 2.0 mm Phillips screws of the camera using the J00 bit from the 54-bit Driver Kit. There are two screws on both sides.
Remove the four 2.0 mm Phillips screws of the camera using the J00 bit from the 54-bit Driver Kit. There are two screws on both sides.
1024
Step 2
- Remove the 4.0 mm Phillips screw located on the bottom of the camera.
Remove the 4.0 mm Phillips screw located on the bottom of the camera.
Step 3
- Remove the front face panel of the camera by hand using firm pressure.
- If one point of the face is stuck to the body, check if there is a screw preventing the front face from coming off.
Remove the front face panel of the camera by hand using firm pressure.
If one point of the face is stuck to the body, check if there is a screw preventing the front face from coming off.
Step 4
- Remove the rear panel of the camera by hand using firm pressure.
Remove the rear panel of the camera by hand using firm pressure.
Step 5
- Remove the user interface panel by hand. The panel may fall out on its own, this is normal.
- Replace the user interface panel by setting it in position.
Remove the user interface panel by hand. The panel may fall out on its own, this is normal.
Replace the user interface panel by setting it in position.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Braxton Beal
Member since: 01/30/2018
681 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Baylor, Team S1-G3, Johnson Spring 2018
Member of Baylor, Team S1-G3, Johnson Spring 2018
BU-JOHNSON-S18S1G3
3 Members
4 Guides authored
