Difficulty

Easy

Steps

2

Time Required

                          5 minutes

Sections

  • Back Cover
  • 1 step
  • LCD Display
  • 1 step

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackCanon Powershot SD880

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove the two 2.4 mm screws on the side of the camera that are next to the LCD screen using a Phillips #00 screwdriver.
  • Remove the two 4.1 mm screws on the other side using a Phillips #00 screwdriver.
  • One screw will be located under the rubber USB flap.
  • Remove the single 2.6 mm screw from the bottom of the camera using a Phillips #00 screwdriver.
  • Slowly pull the back cover off of the camera.

Remove the two 2.4 mm screws on the side of the camera that are next to the LCD screen using a Phillips #00 screwdriver.

Remove the two 4.1 mm screws on the other side using a Phillips #00 screwdriver.

One screw will be located under the rubber USB flap.

Remove the single 2.6 mm screw from the bottom of the camera using a Phillips #00 screwdriver.

Slowly pull the back cover off of the camera.

1024

Step 2

              LCD Display
  • Remove the two 2.9 mm screws at the top-right corner and bottom-left corner of the LCD screen using a Phillips #0 screwdriver.
  • Disconnect the ribbons that connect the screen to the camera.
  • Lift the screen off.

Remove the two 2.9 mm screws at the top-right corner and bottom-left corner of the LCD screen using a Phillips #0 screwdriver.

Disconnect the ribbons that connect the screen to the camera.

Lift the screen off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 8 other contributors 


                    Ben Tupas

Member since: 01/13/2011

317 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 13-3, Forte Winter 2011                        

                                                  Member of Cal Poly, Team 13-3, Forte Winter 2011 



                    CPSU-FORTE-W11S13G3                     


                                            5 Members                     


                                            8 Guides authored

Maelduin - Aug 8, 2013

Reply

Hm. “Disconnect the ribbons” resulted in a torn ribbon, and so a dead camera, I think. This also doesn’t say how to take the LCD screen out of its frame. Alas.