Difficulty

Moderate

Steps

6

Time Required

                          15 - 20 minutes

Sections

2

  • Lithium Ion Battery
  • 2 steps
  • LCD Screen
  • 4 steps

Flags

0

  • BackCanon PowerShot SX10 IS

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Lithium Ion Battery
  • Open the door. Release the catch by sliding it towards the side of the camera.
  • Then slide the door towards the front of the camera.

Open the door. Release the catch by sliding it towards the side of the camera.

Then slide the door towards the front of the camera.

1024

Step 2

  • Remove AA batteries.
  • Using a fingernail or iFixit opening tools to pry up the battery cradle.
  • Remove CR1220 battery from the cradle.

Remove AA batteries.

Using a fingernail or iFixit opening tools to pry up the battery cradle.

Remove CR1220 battery from the cradle.

Step 3

              LCD Screen
  • Remove all four screws on the corners of the screen cover.
  • Gently pry open the cover with a fingernail or iFixit opening tool.

Remove all four screws on the corners of the screen cover.

Gently pry open the cover with a fingernail or iFixit opening tool.

Step 4

  • Remove two screws holding on the cover plate on the pivot.
  • Remove the cover plate using an iFixit opening tool.
  • You may need to loosen the bottom first, then pry on the top of the cover plate.
  • Remove the two screws on top of the swivel arm. These two screws will be separated by the pivot point.

Remove two screws holding on the cover plate on the pivot.

Remove the cover plate using an iFixit opening tool.

You may need to loosen the bottom first, then pry on the top of the cover plate.

Remove the two screws on top of the swivel arm. These two screws will be separated by the pivot point.

Step 5

  • Remove grounding wire, then continue to remove the screws holding the screen and front cover plate on.
  • The screen and plate will drop after removing the last screw.

Remove grounding wire, then continue to remove the screws holding the screen and front cover plate on.

The screen and plate will drop after removing the last screw.

Step 6

  • Unlatch the ribbon strip and power wires from the circuit board.

Unlatch the ribbon strip and power wires from the circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    garrett knox

Member since: 04/05/2019

315 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Oregon Institute of Technology, Team S2-G6, Lancaster Spring 2019                        

                                                  Member of Oregon Institute of Technology, Team S2-G6, Lancaster Spring 2019 



                    OIT-LANCASTER-S19S2G6                     


                                            3 Members                     


                                            5 Guides authored